Smart Locks
A deadbolt that seats flush, throws cleanly, and pairs with your app before the installer leaves.
What Goes Wrong
The most common smart lock failures trace back to skipped fit checks and rushed calibration, not the lock itself.
A lock forced into a non-matching bore sits proud of the door face, leaving gaps that compromise the deadbolt seal.
The bore diameter, backset, and door thickness are measured before any fitting begins, confirming the lock seats flush.
A strike plate set even a few millimeters off causes the bolt to bind, so the lock motor strains and the deadbolt never fully extends.
The strike plate is repositioned until the bolt throws the full 1-inch distance and retracts without resistance.
A lock installed without motor calibration learns the wrong torque, leading to stiff operation or a keypad that stops responding.
After fitting, the lock is powered on and calibrated so the motor learns the exact torque needed for that specific door.
Leaving app setup to the homeowner after the visit means codes go untested and access gaps are discovered at the worst moment.
A full lock and unlock cycle from both the app and keypad is completed with you present before the installer closes the job.
Scope of Work
From bore check to app pairing, every stage of the fitting is included in a single visit.
The deadbolt and latch assembly are seated into the existing bore and aligned so the bolt throws cleanly into the frame.
The strike plate is set to the correct position so the bolt extends the full 1-inch throw without binding or resistance.
After fitting, the motor is calibrated to the specific door so torque is correct and the lock operates smoothly every time.
App connection and keypad code setup are completed on-site, with a full lock and unlock test before the visit ends.
Diameter, backset, and door thickness verified before fitting.
Battery pack installed and power confirmed at calibration.
Door specs checked against building management requirements.
We confirm the lock pairs and operates after the visit.
Why Choose Us
Every job is arranged with accountability built in, written scope, vetted partners, and a follow-up check after the work is done.
You receive an itemized scope and price in writing before a single fitting begins, with no surprises on the invoice.
We connect customers with vetted local partners who carry out the physical fitting and calibration on every job.
After the visit, we follow up to confirm the lock pairs, the app connects, and the keypad responds as expected.
Our partners serve River Oaks, Central Houston, and West Houston, so scheduling a local visit is straightforward.
We arrange smart locks alongside monitored alarms, cameras, and video doorbells so every entry point is covered.
How It Works
01
Tell us about your door and lock model, and we arrange a free on-site visit to measure the bore, thickness, and backset.
02
You receive an itemized quote covering fitting, calibration, and pairing before any work is scheduled or started.
03
The installer fits the deadbolt, aligns the strike plate, calibrates the motor, and confirms app and keypad pairing on-site.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Standard smart lock installation | $150-$300 |
| Keypad and Bluetooth smart lock | $150-$300 |
| Smart lock on upgraded door hardware | $250-$450 |
Tell us about your door and we arrange a free on-site estimate, written scope, and a follow-up check after the fitting is done.